| 1 | Components having more details can easily produced by: (a) extrusion (b) hot rolling (c) casting (d) none of them |
2 | The bottom half of the casting is termed as: (a) bottom (b) cope (c) drag (d) end |
| 3 | Cores are used to: (a) remove pattern easily (b) increase strength of mould (c) make desired recess in casting (d) uniform distribution of molten metal |
4 | The top half of a casting used in moulding is termed: (a) drag (b) top (c) set (d) cope |
| 5 | A sprue pin is used in casting to: (a) hold the cast together (b) form the hole for the molten metal (c) make small holes to allow the gas to escape (d) smooth the face of the mould |
6 | The tool used to cut a channel to allow molten metal to enter a casting mould is termed a: (a) channel cutter (b) gate cutter (c) sand cutter (d) ream cutter |
| 7 | The main aim of gate is: (a) to help in feeding casting materials. (b) to provide storage capacity for molten metal. (c) to feed the casting at a rate consistent with the rate of solidification. (d) none of them. |
8 | Cores are used for: (a) act as the supporting device (b) give strength to the moulding sand. (c) both (a) & (b) (d) making desired recess in casting. |
| 1 | c | 2 | c |
| 3 | c | 4 | d |
| 5 | b | 6 | b |
| 7 | c | 8 | d |